User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Powering on the Router
Do not touch the power supply when the power cord is connected. For systems with a power switch, line
voltages are present within the power supply even when the power switch is off and the power cord is
connected. For systems without a power switch, line voltages are present within the power supply when
the power cord is connected. Statement 4
Warning
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal
use. Statement 39
Warning
Checklist for Power on
•
Securely mount the router.
•
Properly connect the power, network, and interface cables.
Interpreting Bottom-Panel LEDs
The Cisco ASR 901S Aggregation Services Router provides three LEDs on the bottom panel to monitor
conditions and to aid in troubleshooting problems. For a description of the LEDs, see
Reading LEDs , on
page 70.
Complete these steps to power on the Cisco ASR 901S Aggregation Services Router and verify its initialization
and self-test:
Procedure
Step 1
Remove the tape from the circuit breaker switch handle.
Step 2
Restore power by moving the handle of the circuit breaker to the ON position.
The System LED on the bottom panel should go ON.
Depending on your installation, the other bottom-panel LEDs can also come on.
If you encounter problems when you power on the router, see the
Troubleshooting, on page 67.
Enabling Zero Touch Provisioning on the Router
Before You Begin
•
Phillips screwdriver
•
Straightened paperclip or thin non-metallic pin no larger than 3/16 inches in diameter
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 61
Installing the Router
Powering on the Router
REVIEW DRAFT - CISCO CONFIDENTIAL