User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Procedure
Step 1
Use a Phillips screwdriver to remove the zero touch provisioning (ZTP) reset button screw. Be careful not to
loose the screw.
Step 2
Use a straightened paperclip, thin non-metallic pin, or thin non-metallic pin no larger than 3/16 inches in
diameter and push the ZTP reset button for 0.5 seconds to initiate zero touch provisioning. (See the following
figure.)
Figure 34: Accessing the ZTP Reset Button
ZTP reset button1
Push the ZTP reset button for more than 8 seconds to reboot (power cycle); all LEDs will turn off for
approximately 5 seconds, and then the LEDs will reactivate.
Step 3
Replace the reset button screw and use a Phillips screwdriver to tighten to 22 to 24 in. lbs (2.49 to 2.71 Nm).
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
62 OL-29732-01
Installing the Router
Enabling Zero Touch Provisioning on the Router
REVIEW DRAFT - CISCO CONFIDENTIAL