User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
•
FCC 47CFR15, Class B
•
EN55022, Class B
•
CISPR 22, Class B
•
AS/NZS CISPR 22, Class B
•
ICES 003, Class B
•
VCCI, Class B
•
KN 22, Class B
•
CNS-13438
•
EN61000-3-3 Voltage Changes, Fluctuations, and Flicker
•
EN61000-3-2 Power Line Harmonics
•
KN 22
•
EN61000-3-12 Power Line Harmonics
•
EN61000-3-11 Voltage Fluctuations and Flicker
EMC emissions
•
EN/IEC61000-4-2 Electrostatic Discharge Immunity - Enclosure
•
EN/IEC61000-4-3 Radiated Immunity - Enclosure
•
EN/IEC61000-4-4 Electrical Fast Transient Immunity
•
EN/IEC61000-4-5 Surge
•
EN/IEC61000-4-6 Immunity to Conducted Disturbances
EMC immunity
This product is designed to meet the following requirements:
•
GR-63-CORE
•
GR-1089-CORE
Network Equipment Building
Standards (NEBS)
•
EN 300 386 Telecommunications Network Equipment (EMC)
•
EN55022 Information Technology Equipment (Emissions)
•
EN55024 Information Technology Equipment (Immunity)
•
EN61000-6-1 Generic Immunity Standard
ETSI/EN
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 75
Specifications and Part Numbers
Product Specifications
REVIEW DRAFT - CISCO CONFIDENTIAL