User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
APPENDIX B
Cable Specifications
If you prefer to build your own cables, this appendix provides cable specifications for the Cisco ASR 901S
Series Aggregation Services Router.
The appendix includes the following sections:
•
Gigabit Ethernet Connector Pinouts , page 79
•
SFP and SFP+ Port Pinouts and Cable Specifications , page 80
•
Console Port Signals and Pinouts, page 82
•
Alarm Port Pinouts, page 83
•
Management Ethernet Port Pinouts, page 83
Gigabit Ethernet Connector Pinouts
This section illustrates the Gigabit Ethernet RJ-45 connector and lists its pinout and signal descriptions.
The RJ-45 ports are capable of operating in both 100BaseT and 1000BaseT modes.Note
The following figure shows the RJ-45 connector and port, and the table lists the connector pinouts and signals.
Figure 35: Connector and Port
GE SignalFE SignalPin
TX A+TX data+1
TX A-TX data-2
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 79