User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
RX B+RX data+3
TX C+Not used4
TX C-Not used5
RX B-RX data-6
RX D+Not used7
RX D-Not used8
SFP and SFP+ Port Pinouts and Cable Specifications
The following figures show the SFP and SFP+ modules supported by the Cisco ASR 901S Series Aggregation
Services Router.
Pins not listed in the tables in this appendix are not connected.Note
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
80 OL-29732-01
Cable Specifications
SFP and SFP+ Port Pinouts and Cable Specifications
REVIEW DRAFT - CISCO CONFIDENTIAL