User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
The Cisco ASR 901S Series Aggregation Services Router supports the SFP module patch cable, a 0.5-meter,
copper, passive cable with SFP module connectors at each end (see the following figures).
Figure 36: Duplex LC Cable Connector
Figure 37: Simplex LC Cable Connector
Figure 38: Copper SFP Module RJ-45 Connector
Figure 39: SFP Module Patch Cable
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 81
Cable Specifications
SFP and SFP+ Port Pinouts and Cable Specifications
REVIEW DRAFT - CISCO CONFIDENTIAL