User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Alarm Port Pinouts
The following table lists the pinouts for the alarm port (RJ45) on the Cisco ASR 901S Series Aggregation
Series Router.
DescriptionSignal NamePin
—
Alarm input 11
—
Alarm input 22
Not connected
—
3
—
Alarm input 34
—
Alarm input 45
Not connected6
Not connected7
Not connected8
Management Ethernet Port Pinouts
The following table lists the pinouts for the management Ethernet port (RJ-45) on the Cisco ASR 901S Series
Aggregation Services Router.
DescriptionSignal NamePin
—
RxD_P1
—
RxD_N2
—
TxD_P3
Not connected
—
4
Not connected
—
5
—
TxD_N6
Not connected
—
7
Not connected
—
8
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 83
Cable Specifications
Alarm Port Pinouts
REVIEW DRAFT - CISCO CONFIDENTIAL