- Cisco Network Router User's Manual

CiscoAironetAccessPointDeploymentGuide
CiscoSystems
Copyright©2012CiscoSystems,Inc.Allrightsreserved.
Page16of52
Figure20:OptionalAIRAPBRACKET3forInstallationofAPsintoCeilingTiles
Usethe“beautyring”asatemplatetocutthetile.Ciscodoesnotoffercustomcuttilesbutthetilesare
easytocutwithacarpetknifeorelectrictoolsuchastheDremel™
orRotozip™rotarycuttingtool.
AmetalrailthatextendsthelengthofthetilesupportstheAPabovetheceil ing ifthetilebecomeswet
orotherwisefails.AmechanicalsetscrewpullstheAPtight totheceilingandlocksitintothebracket.
Additionally,aKensingtonstyle
lockcanbeusedforphysicalsecurityoftheAP,but,oncei nstalled,itis
difficulttoremovetheAPwithoutremovingthetilesincetheAPdoesnotslideoutfromthefrontside
ofthetile.
Note:ThisbracketfitstheAP1040,1140,1260,1600,2600,3500,
and3600.
InstallationonWalls
Wallscanbea physicalobstacletothewirelesssignalandmaycompromise360degreecoverage.Ifthe
wall is an outside wall or if the goal is to send the signal in a 180degree pattern rather than a 360
degree pattern, a directional antenna (often referred to as
a patch antenna) used with the AP 3600e
maybeabetterchoice.
Avoid wallmounting APs with internal antennas such as the AP 3600i. The internal antenna model is
designed to mount to a ceiling to provide 360degree coverage. If wallmounted in a nonhorizontal
orientation, the signal
may penetrate floors and ceilings. This causes unintended coverage and may
result in additional, needless roaming access when, for example, a user with WiFi phone walks on an
adjacentfloor.
