- Cisco Network Router User's Manual

CiscoAironetAccessPointDeploymentGuide
CiscoSystems
Copyright©2012CiscoSystems,Inc.Allrightsreserved.
Page47of52
Figure61:ExampleofChannelUsagein2.4and5GHz(TwoChannelsusedif40MHz)
Try to determine which clients will be used and check the coverage using those clients. For
example, a PDA or WiFi phone might not have the same range as a
notebook or tablet.
Tip:Verifycoverageusingtheworstperformingclientsthatyouintendtodeploy.
Ifyou require threespatialstreamcoverage for the fastest throughput orifyouwant the bes t
BYODexperience,theAP3600andtheAP2600withClientLink2.0outperformtheAP
3500.The
AP 3600 can beamform to 802.11n clients, so it is important to understand the data
requirementsifyoumixtheAP1260,3500,and3600inthesameareas.
While site surveys are generally recommended, if the design is done at half power and Cisco
RRM is
in place, a limited site survey may be adequate for smaller venues. In very challenging
environments such as train connectivity, Gas & Oil verticals, large hospitals, and so forth, you
can contract with the Cisco Advanced Services team to help or to perform your installation.
ContactyourCiscoaccountteamfor
moreinformation.
The AP 3600 was introduced in the 7.1.91 or higher code stream and is supported by the
following: Cisco 2500, 7500, 5508, and WiSM2 Series Controllers, WCS 7.0.220 or higher, and
NCS1.1orhigher.TheAP1600andtheAP2600wereintroducedinthe7.4
release.
Theruleofthumbcoverageplanis:oneAPper5,000squarefeetfordataandoneAPper3,000
squarefeetforvoiceandlocationservices.
Some clients (especially older ones) do not support the UNII2 extended client channels 100
140;therefore,if you
haveolderclients,youmaywanttodisablethemintheDCAchannellist.
Note: The newer 802.11ac clients support these channels, and more clients are starting to
supportthesechannelsall thetime.