User Manual
Table Of Contents
- Cisco Connected Grid 3G Module Installation and Configuration Guide
- Kit Contents
- Features
- Hardware Overview
- Front Panel
- Ports and LEDs
- Supported Cisco Antennas
- Supported Cisco Cables
- 3G Module Models
- Interfaces
- Radio Frequency Interface
- Environmental Specifications
- Power Specifications
- Modem
- GSM Module SIM Interface
- Voltage Monitoring State Machine
- Temperature Monitoring State Machine
- Data Rates
- USB Interface
- Memory Specifications
- Module Power States
- Installing and Removing the SIM Card (GSM Module)
- Installing and Removing the 3G Module
- Regulatory and Compliance Information
- Software Overview
- Configuring the Module
- Configuration Example
- Additional References
- Technical Assistance
- Troubleshooting and Diagnostics
10
Cisco Connected Grid 3G Module Installation and Configuration Guide
OL-25991-01
Hardware Overview
Supported Cisco Antennas
The antenna is connected to the QMA, panel-mount, 50-ohm connector located on the faceplate of the
module. The modem mini-card antenna connector is a U.FL, 50-ohm, with a short 50-ohm coaxial cable
to the QMA connector.
For more information about antennas, including installation procedures, see Cisco and 1120 Connected
Grid Router Hardware Installation Guide.
Table 4 lists the Cisco antennas that are supported for use with the module and the Cisco 1120 Connected
Grid Router.
Table 4 CGR 1120—Supported Antennas and Cables for Use With the 3G module
Cisco 1120 Connected Grid Router
Case Description Indoor Cable
Lightning
Arrestor Outdoor Cable Antenna
Case 1: 2G/3G Connected
Grid Module, 10’, 15’ or
20’ cable thru conduit or
building entry panel
passthrough, Stick Omni
or Directional Flat Panel
antenna
• QMA(f), qty 2
RA-QMA(m) to N(m),
LMR-240-DB, 10’, qty 2
• 37-1351-02
• CAB-L240-10-QMA-N
None Same cable as indoor
cable, i.e. single cable
runs from inside to
outside, through conduit.
4G Omni Stick, N(f), qty 2
• 07-1166-01
• ANT-4G-OMNI-OUT-N
RA-QMA(m) to N(m),
LMR-240-DB, 15’, qty 2
• 37-1352-02
• CAB-L240-15-QMA-N
3G, 806-960 MHz, 1710-2170
MHz, Flat Panel Antenna,
10/11 dBi, MPN PCTEL
FP8241805-10VP, qty 2
• 07-1162-01
• ANT-3G-PNL-OUT-N
RA-QMA(m) to N(m),
LMR-240-DB, 20’, qty 2
• 37-1353-02
•
CAB-L240-20-QMA-N
Case 2: 2G/3G Connected
Grid Module, Indoor
Cable, Lightning Arrestor,
Outdoor Cable, Stick
Omni or Directional Flat
Panel antenna
• QMA(f), qty 2
RA-QMA(m) to N(m),
LMR-240-DB, 10’, qty 2
• 37-1351-02
• CAB-L240-10-QMA-N
Lightning Arrestor,
N(f)-N(f), qty 2
• 07-1158-01
• CGR-LA-N-N
RA-N(m) to N(m),
LMR-400-DB, 20’, qty 2
• 37-xxxx-01
• CAB-L400-20-N-N
4G Omni Stick, N(f), qty 2
• 07-1166-01
• ANT-4G-OMNI-OUT-N
RA-N(m)-N(m),
LMR-600-DB, 30’
• 37-yyyy-01
• CAB-L600-30-N-N
3G, 806-960 MHz, 1710-2170
MHz, Flat Panel Antenna,
10/11 dBi, MPN PCTEL
FP8241805-10VP, qty 2
• 07-1162-01
• ANT-3G-PNL-OUT-N
Case 3. 2G/3G Connected
Grid Module, Low Profile
Antenna with Integrated
15” coax cable, Mounted
to top of Utility Cabinet
Roof
• QMA(f), qty 2
None Connector
Adaptor,
QMA(m)-TNC(f),
MPN H+S
33_QMA-TNC-50
-1, qty 2
• CPN
• PID
None










