User Manual

31
Cisco Connected Grid 3G Module Installation and Configuration Guide
OL-25991-01
Configuring the Module
DETAILED STEPS
Activating the Module Using OTASP (CDMA Module)
To activate the module using Over-The-Air Service Provisioning (OTASP), use the cellular 3/1 cdma
activate otasp *22899 command.
Note Do not hit a Enter (carriage return) until provisioning is complete—you will see “Over the air
provisioning complete; Result = Success.” See below.
Router# cellular 3/1 cdma activate otasp *22899
Beginning OTASP activation
OTASP number is *22899
Router#
<-- Do not hit Enter key-- provisioning is in process.
OTA State = SPL unlock, Result = Successprovising
OTA State = Profile downloaded, Result = Success
OTA State = MDN downloaded, Result = Success
OTA State = Parameters committed to NVRAM, Result = Success
Over the air provisioning complete; Result = Success <-- Activation successful. Hit Enter to return to prompt
Router#
To verify that the account has been provisioned and the modem has been activated, use the show cellular
3/1 profile command in EXEC mode:
Router# show cellular 3/1 profile
* - Default profile
GSM Cellular Interface Configuration
To configure the cellular interface:
Step 1 Create a profile on the interface 3/1 using the cellular command:
Router# cellular 3/1 gsm profile create 1 <Access Point Name> [<username> <password>]
Step 2 Configure terminal:
Step Command Purpose
Step 1
show cellular 3/1 network Displays information about the carrier network, cell site, and
available service.
Step 2
show cellular 3/1 radio Shows the radio signal strength.
Note The RSSI should be better than -90 dBm for steady
and reliable connection.
Step 3
show cellular 3/1 profile Shows information about the modem data profiles created.
Step 4
show cellular 3/1 security Shows the security information for the modem, such as SIM
and modem lock status.
Step 5
show cellular 3/1 all Shows consolidated information about the modem, profiles
created, radio signal strength, network security, and so on.