User Manual
Table Of Contents
- Cisco Connected Grid 3G Module Installation and Configuration Guide
- Kit Contents
- Features
- Hardware Overview
- Front Panel
- Ports and LEDs
- Supported Cisco Antennas
- Supported Cisco Cables
- 3G Module Models
- Interfaces
- Radio Frequency Interface
- Environmental Specifications
- Power Specifications
- Modem
- GSM Module SIM Interface
- Voltage Monitoring State Machine
- Temperature Monitoring State Machine
- Data Rates
- USB Interface
- Memory Specifications
- Module Power States
- Installing and Removing the SIM Card (GSM Module)
- Installing and Removing the 3G Module
- Regulatory and Compliance Information
- Software Overview
- Configuring the Module
- Configuration Example
- Additional References
- Technical Assistance
- Troubleshooting and Diagnostics
6
Cisco Connected Grid 3G Module Installation and Configuration Guide
OL-25991-01
Hardware Overview
• Voltage Monitoring State Machine, page 15
• Temperature Monitoring State Machine, page 15
• Data Rates, page 15
• USB Interface, page 15
• Memory Specifications, page 16
• Module Power States, page 16
Front Panel
Figure 2 shows the front panel components of the 3G module.
Figure 2 Front Panel of the 3G module
1 Captive screws (2) 2 Auxiliary port
1
1. QMA connector for antenna is used for optional RX diversity or GPS antenna. Since the module GPS is not used (GPS of host
router is used), connector must be terminated with a 50-Ohm terminator.
3 Main port
2
2. QMA connector for antenna—transmits and receives RF.
4 SIM card slots
5 RSVD
3
3. Mini-USB port (can be diagnostic port).
6 LEDs
4
4. WWAN, RSSI, SVC1, SVC2, SIM1, and SIM2.
284022
AUX
MAIN
RSVD
WWAN RSSI
SVC GPS
SIM1 SIM2
TEXT DIRECTION
1 12 3
45
6