User's Manual

DEC. 2011—EFT REVIEW DRAFT—CISCO CONFIDENTIAL
4-10
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-12345-01
Chapter 4 Mounting the Router
Mounting Instructions
What you need
• Mounting plate and steel straps included in the Pole Mount Kit.
• Band-It tool included in the Strap Tool Kit
Step 1 Assemble the straps and the mounting plate by threading the two steel straps through the band strap slots
on the mounting plate.
Step 2 Select a mounting location on the pole.
Step 3 Position the mounting plate on the pole as needed and tighten the straps around the pole.
Step 4 Use the Band-It strap tool to tighten the metal bands around the pole, following the instructions in the
box with the tool. Ensure the metal bands are as tight as possible.
Note When the metal bands are tightened to the full tension, the mounting plate cannot be adjusted unless the
metal bands are disassembled or cut.
Figure 4-8 Mounting Plate Installed on Pole with Steel Straps