User's Manual

DEC. 2011—EFT REVIEW DRAFT—CISCO CONFIDENTIAL
4-14
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-12345-01
Chapter 4 Mounting the Router
Mounting Instructions
To attach the mounting bracket to the mounting plate, follow these steps and refer to Figure 4-12. The
mounting plate must be installed according to the instructions in the Install the Mounting Plate on a Pole
section.
What You Need
• Mounting bracket and hardware included in the Mounting Bracket Kit.
• Socket wrench that you supply.
Step 1 Assemble four sets of bracket hardware (washer, split lock washer, and bolt) as shown in the section
Assemble Bracket Hardware, page 4-12.
Step 2 Place the mounting bracket (3) against the mounting plate (1) by inserting the bracket quick hang notch
over the mounting plate quick hang stud (
6).
Step 3 Align the pivot grooves (4) on the bracket with four of the bracket mount holes (2) on the mounting plate.
Follow these guidelines:
• Each of the four pivot grooves on the bracket must be attached to at least one bracket mount hole on
the mounting plate.
• The final desired orientation of the mounting plate and router determine which bracket mount holes
are used.
• Mount the router according to the instructions in the Router Orientation section.
Step 4 Thread the serrated nut onto the quick mount stud (6) and hand tighten (do not overtighten).
Step 5 Insert one bolt assembly (5) through one of the pivot grooves (4) on the bracket and then through the
corresponding bracket mount hole on the mounting plate.
Step 6 Repeat Step 5 for the remaining bolt assemblies.
Step 7 Position the mounting bracket on the mounting plate as needed before further tightening the bolts.
Step 8 Use a socket wrench to evenly tighten all four bolts and the serrated nut to finish installing the bracket
on the plate.
Item Description
1 Pivot grooves (4)
2 Quick hang notch
3 Quick hang slots (2)
4 Wall mount holes (4)