User's Manual

DEC. 2011—EFT REVIEW DRAFT—CISCO CONFIDENTIAL
4-15
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-12345-01
Chapter 4 Mounting the Router
Mounting Instructions
Figure 4-12 Mounting Bracket Attached to Mounting Plate
Install the Router on the Mounting Bracket
This section describes how to attach the router to the mounting bracket. The instructions for the
procedures in this section refer to the mounting bracket kit contents shown in
Figure 4-2 and the bracket
features described in Figure 4-11.
What You Need
• Mounting bracket and hardware included in the Mounting Bracket Kit.
• Socket wrench that you supply.
To mount the router on the bracket, take these steps and refer to Figure 4-13 and Figure 4-14:
Step 1 Assemble eight sets of bracket hardware (washer, split lock washer, and bolt) as shown in the section
Assemble Bracket Hardware, page 4-12.
Step 2 One each side of the router, attach one set of hinge bolt hardware to the mounting bracket connector (1).
Do not tighten the hardware until Step 5. There must be enough space between the washer and the router
to slide the router onto the bracket.