User's Manual

DEC. 2011—EFT REVIEW DRAFT—CISCO CONFIDENTIAL
4-17
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-12345-01
Chapter 4 Mounting the Router
Mounting Instructions
Figure 4-14 Attach Remaining Bolts to Bracket and Router
SD Card Slot Access for Bracket-Mounted Routers
When the Cisco mounting bracket is attached the router according to the instructions in this chapter, the
bracket blocks access to the SD card port slot the router exterior.
To access the SD card slot (1) without removing the router from the bracket or any mounting installation
that uses the bracket, take these steps and refer to
Figure 4-15:
Step 1 One one side of the router, remove the three bolts shown in Figure 4-14.
Step 2 Loosen but do not remove the fourth bolt that is inserted in the quick hang slot.
Step 3 Repeat Step 1 through Step 2 on the other side of the router.
Step 4 Tilt the bracket on the quick mount slot, as shown in Figure 4-15.
Caution Be sure to reinstall and tighten all eight bolts when you finish using the SD card slot. The router must
be securely attached to the mounting bracket with four bolts on each side.