User's Manual

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev D v1.0 155
February 28, 2003
IP
Field Name Values Description
BTS IP Address
Unique IP address for each BTS. Space bar used to
remove or skip existing digits.
EMS Server IP Address
Unique IP address for an EMS. Defaults to the IP on
which the EMS Server is running. Space bar used to
remove or skip existing digits.
BTS Default Gateway
Default Gateway used to route IP packets for a BTS.
BTS Subnet Mask
Subnet Mask used to route IP packets for a BTS.
Street Address
Physical location of this BTS.
City
City in which BTS is located.
State
State in which BTS is located.
Zip
Zip code for location in which BTS is located
BTS ID
Unique numeric identification number for this BTS.
Cannot be changed once the BTS is created in the
system.
BTS Name
Unique name given to this BTS. No two BTS’s can have
the same name.
Suppress Alarms
TRUE or FALSE To suppress alarms from BTS to EMS, set to TRUE until
problem is resolved. Useful if BTS is flooding EMS and
affecting its performance. To allow alarms to be sent, set
to FALSE.
Suppress CPE Registration
TRUE or FALSE Determines if BTS can send CPE Registration messages
to EMS. Useful if BTS is flooding EMS and affecting its
performance. To allow messages to be sent, set to
FALSE.
Calibration Interval
(hours)
1
- 24 The interval of hours by which on-line calibration occurs.
Bridge Aging Timer
(minutes)
1 - 60
BTS Bridge Table timer that controls how long a PVC is
assigned to an EID (CPE). The PVC to EID association is
removed when no user traffic is received for the timer
interval. Applicable only when dynamic PVC assignment
is used.
Enable PVC Loopback
TRUE or FALSE Determines if any PVC on this BTS can perform
loopback test.
BTS Contact Personnel
Textual identification of a contact person for this BTS
and how to contact them.
BTS Configuration Source
EMS or BTS Determines where the BTS obtains its configuration data
when reset. If provisioning BTS for first time, set to
EMS. After successful reset, defaults to BTS.
Interface Type
Ethernet or ATM Indicates the backhaul to which the BTS is connected.
BTS Profile Type
Unlicensed 2.4 GHz
MMDS 2.6 GHz
Select the correct system. 2.4 GHz is the only unlicensed
frequency. Any other system, 2.3, 2.5, and 2.6, select
MMDS.
Frequency
2.305 GHz - 2.359
GHz
2.40 GHz - 2.473
GHz
2.50 GHz - 2.595
GHz
Scroll bar that allows you to set the center frequency for
the BTS operation. The range depends on the type of
system, i.e., 2.3 GHz, 2.4 GHz, 2.5 GHz, 2.6 GHz. The
field is operated by clicking on the center frequency
scroll bar and moving it left or right. The center
frequency of an MMDS band BTS must match what is
hard-wired on the RFS. During installation, the installers
should check that the configured center frequency is
identical to the center fre
q
uenc
y
labeled on the Channel