User's Manual

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev D v1.0 167
February 28, 2003
BTS list at the bottom of the screen. When enabled, the
Current Home BTS list is ignored. If disabled, this CPE
can only access a BTS in its Available Home BTS list.
Admin Status
Active
Active or Suspended. If suspended, the CPE cannot
access any BTS. A Service Provider may decide to make
the CPE suspended due to late service payments, security
concerns, etc., rather than deleting the CPE from the
system database.
Home BTS
Field Name Values Description
Available Home BTS
Add or Remove BTS Names. A list of available BTS’s to
include in the Current Home BTS list for this CPE.
Current Home BTS
Add or Remove BTS Names. If Nomadic is disabled,
these are the only BTS’s this CPE can access. If Nomadic
is enabled, this list is ignored.
Layer 3
Field Name Values Description
Ingress Acl
(Checkbox) If checkbox is clicked “on” any incoming packet whose
MAC address cannot be found in the current CPE
Authenticated IP List will be discarded.
Ingress Broadcast
(Checkbox) If checkbox is clicked “on” any incoming MAC
broadcast message will be discarded.
DHCP Relay
Field Name Values Description
Free Address High Drop
Policy
Drop most recently
leased or Drop least
recently leased
Drop the most recently leased or least recently leased IP
addresses
Max Address Number
Drop most recently
leased or Drop least
recently leased
Drop the most recently leased or least recently leased IP
addresses
IP Address
Field Name Values Description
Static Client IP Address
0.0.0.0
Use static, rather than dynamic, IP addressing for this
device. If static IP assignment is being made, add this IP
address to the Ingress Filter Authenticated IP List.
Otherwise, leave zeroes.
Hardware Address
0:0:0:0:0:0
Enter the Ethernet address of the host computer to which
the CPE is connected and that corresponds to the above
Client IP Address.