User's Manual

Ripwave Base Station I&C Guide Navini Networks, Inc.
198 Part #40-00047-00 Rev D v1.0
February 28, 2003
BTS Mechanical & Electrical Specifications
Table J1: 2.6 GHz BTS
Physical:
2.3, 2.6GHz Split Digital & RF Chassis
Mechanical Dimensions Digital:
19” X 19” X 13” (HWD)
Mechanical Dimensions RF
14” X 19” X 13” (HWD)
DC Power:
1,353 Watts, 21VDC to 28VDC @ 56A (4,618 BTU)
DC Power Interface:
2 - ¼” lugs for +24Vdc and 24VReturn
Operational Temperature Range:
0 to +50 degrees C
Storage Temperature Range:
-40 to +70 degrees C
Weight:
100 lbs.
Service Accessibility:
Front and rear access required
Humidity:
0 to 95% non-condensing
Table J2: BTS to RFS Interface
RFS Antenna (per BTS):
8 Type N Female Connectors
RFS Antenna Calibration (per
BTS):
1 Type N Female Connector
RFS Antenna Power/Data (per
BTS):
Burndy G6B14-92PNE-32 Power Connector (1.0625”
OD). The power connector is part of a pre-terminated
cable assembly ordered in 25’ increments. The power
data cable assembly utilizes an Alpha Wire (P/N 5136C)
composite cable.
GPS Antenna:
2 Type N Female Connectors
Network (WAN) Interfaces
T1/E1 Interface
Number of T1/E1’s:
8
Standards Compliance:
ANSI, Bellcore ANSI T1.403
Line Coding:
AMI/B8ZS
Inverse Multiplexing ATM
(IMA):
Spec 1.1
ATM
Standards Compliance:
UNI 4.0
Number of PVC’s:
2000
ATM Adaptation:
AAL5 ATM Adaptation (VBR real, VBR Non-Real,
UBR)
Bridging Protocol:
RFC 1483 (LLC, SNAP)
Ethernet
Standards Compliance:
10/100BaseT (Ipv4) Ethernet
QoS:
Diffserv, Class based queuing (3 priority queues), WFQ
Packet Format:
IEEE 802.3 / Ethernet II