User's Manual

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev D v1.0 233
February 28, 2003
Appendix Q: Sample Statement of Work
The following is an example of a Statement of Work. The Statement of Work outlines the
general activities that must be conducted in order to complete the installation and commissioning
tasks for a Ripwave Base Station.
Example:
Statement of Work for Standard Installation Services
The following statement of work will be used to outline the areas of responsibilities for the
Navini Networks antenna (known as the RFS) and Base Station (known as the BTS) installations
to be completed with Navini Networks Client (referred to as Client in this document). Client
may choose to hire a contractor or tower crew to assist with its activities. Navini Networks has
no formal contract relationship with the contractor, who will be managed by Client. The
following work items are suggested content only - - final scope and terms to be negotiated
directly with Client. Navini Networks support personnel will be on site for the entire installation
and commissioning process, and will provide technical expertise, information, and
recommendations with respect to site design and installation.
It is recommended that contractor have a Non-Disclosure Agreement (NDA) in place with Client
and Navini Networks prior to execution of work. Contractor shall not publicly disclose any
information concerning this deployment or trial with any other parties, unless approved in
writing in advance by Client and Navini Networks.
Navini Networks
1. Provide Field Engineer to consult with Client and Contractor for planning efforts.
Review Site design sketches and BOM prepared by others.
2. Review network architecture information (connection diagram and logical addresses)
prior to start of installation.
3. Review Sweep results with Client and contractor. Sweep to be provided of RFS after
shipment, of coax cables and RF path on tower, and of cables and RFS after installation,
before power up.
4. Review AC and DC power system installation. Review DC power system test with
Client and contractor.
5. Review backhaul circuit installation test results with Client.
6. Review GPS antenna and cable installations.
7. Review and Verify Cable and Antenna System Installation Work
8. Site walk with contractor and Client for Punchlist.
9. Load EMS software on Client supplied workstation, and verify connectivity to BTS.