User's Manual

Ripwave Base Station I&C Guide Navini Networks, Inc.
72 Part #40-00047-00 Rev D v1.0
February 28, 2003
Figure 44: Ports on CC Card
If the customer’s EMS is installed and can be accessed through the backhaul, it can be connected
via T1 or Ethernet to the BTS and used for testing purposes. The EMS software installation
procedures can be found in the
EMS Software Installation Guide, P/N 40-00017-00.
After the EMS Server and Client applications are installed, the EMS database needs to be
configured with the settings that are designated for the Base Station. The settings are found in the
Network Architecture Plan provided by the customer.
Verify Cable Connections
Before proceeding, verify that all power is connected and present. Ensure that all T1 or Ethernet
connections are installed correctly and are active. Verify that the BTS and the RFS are properly
installed and that all cables are connected.
Ethernet Connector
T1 Connectors
Serial Port Connector
Ethernet Connector
Serial Port Connector
(aka, Console Port)
Ethernet Connector
T1 Connectors
Serial Port Connector
Ethernet Connector
Serial Port Connector
(aka, Console Port)