User's Manual

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev D v1.0 57
February 28, 2003
VIC 100
For the VIC 100, mount each GPS antenna module, run the cable through the pipe clamp mount
(Figure 25). Connect the cable to the GPS antenna, then weatherize the connection (Figure 26).
Secure the antenna module to the pipe clamp mount using the captive mounting hardware. Install
the GPS antenna module and the pipe clamp mount to the mounting pipe and tighten the two
mounting screws (Figure 27).
Figure 25: VIC 100 Pipe Clamp Mount
Figure 26: VIC 100 GPS Antenna
Figure 27: Assembled VIC 100 Antenna & Mount
Captive
Mounting
Hardware
Captive
Mounting
Hardware
GPS antenna
mounting screws
GPS antenna
mounting screws