User's Manual

R E VIEW DR AFT — CISC O C O NFIDE N TIAL
C H A P T E R 2
Installation
This chapter describes the installation/mounting of the CEED3700 (CEED 3700) and contains the
following sections:
This section contains the following sections:
• Mounting Prerequisites, page 2-1
• Mounting of the CEED 3700, page 2-1
• Accessories, Peripherals and Cable Assembly, page 2-6
Mounting Prerequisites
• CEED 3700 is optimally designed for a room size of 20*20 ft. Any deviations shall be suitably
notified and prior approval on the installation with partners (The document assumes a size of 20*20
ft room. Actual position may vary depending on the implementation and other details)
• CEED is placed at 10 to 13 feet from the screen.
• Ensure the celling is strong enough with reinforced concrete (RCC) or steel structures and is capable
of taking at least 20 Kilograms (Kg) of load.
• Ensure ambient room lighting for proper image capture and better image projections.
• Use d r a p es or opaque curtains to block excess light in the room that wi ll interfere the image projection.
Caution Ensure that all “Installation Prerequisites” section on page 1-2 in the Introduction chapter is adhered to
without any deviations.
Mounting of the CEED 3700
To mount the CEED 3700 in the ceiling, perform the following steps:
Step 1 Assign the position of the CEED (from the screen) to be mounted. Align/arrange the top portion of the
mounting kit towards the ceiling as shown in “Top portion of the Moutning Kit” in Figure 2-1.
Remove the portion after you mark the holes.
2-1