User's Manual

Chapter 6 Configuring the Router
Configuring 3G
R E VIEW DR AFT — CISC O C O NFIDE N TIAL
The IP Address, Subnet Mask, Default Gateway, Primary DNS Server, Secondary DNS Server and MTU
value fields will be enabled.
Step 14 Enter the values that you have obtained from the Service Provider in the IP address, Subnet Mask,
Default Gateway, Primary DNS Server, Secondary DNS Server.
Step 15 The MTU Value is set to default 1500.
Step 16 Click Apply and wait for the settings to be applied.
Configuring 3G
To configure 3G network in the router, perform the following steps:
Step 1 Perform Step 1 to Step 7 in the section Configuring WAN, page 6-1.
Step 2 Click Network tab and then choose Cellular as shown in “Cellular Tab” in Figure 6-6.
Figure 6-6 Cellular Tab
Step 3 From the IPS drop-down list, choose the service provider. For example, Airtel.
Step 4 If your Service provider is not listed in the drop-down menu, enter the service provider’s name manually.
Step 5 In the Access point name, dial number , user name and password fields enter the respective values
provided by the service provider.
Step 6 Click Apply and wait for the changes to be applied.
6-5