User's Manual

Modifying the equipment without Cisco's authorization may result in the equipment no longer complying
with FCC requirements for Class B digital devices. In that event, your right to use the equipment may be
limited by FCC regulations,
and you may be required to correct any interference to radio or television
communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These lim
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may caus
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by tur
ning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
• Connect the equ
ipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This mobile phone
complies with part 15 of the
conditions: (1) This device may
interference received, including interference that may
FCC Caution:
Any
Changes or modifications not expressly approved by
the user‘s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co
antenna or transmitter.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying
with FCC requirements for Class B digital devices. In that event, your right to use the equipment may be
and you may be required to correct any interference to radio or television
communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These lim
its are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may caus
e harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
ning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
ipment into an outlet on a circuit different from that to which the receiver is
Consult the dealer or an experienced radio/TV technician for help.
complies with part 15 of the
FCC Rules. Operation is subject to the following
conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any
interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by
the party responsible for compliance could void
the user‘s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co
-located or
operating in conjunction with any other
Radiation Exposure Statement
:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying
with FCC requirements for Class B digital devices. In that event, your right to use the equipment may be
and you may be required to correct any interference to radio or television
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
its are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
e harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
ning the equipment off and on, the user is encouraged to try to correct the
ipment into an outlet on a circuit different from that to which the receiver is
FCC Rules. Operation is subject to the following
two
device must accept any
the party responsible for compliance could void
operating in conjunction with any other
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &