DPH-SO16 Quick Install Guide
Table of Contents CHAPTER 1 INTRODUCTION ............................................................................................. 1 Package Contents .............................................................................................................. 1 LEDs ................................................................................................................................... 2 CHAPTER 2 INITIAL INSTALLATION ...........................................................................
Chapter 1 Introduction 1 This Chapter provides an overview of the device's features and capabilities. This Access Point is a high-capacity enterprise Femtocell product that provides consumers with low cost calls using their 3G handsets and home broadband connection. This product will bring high-quality 3G coverage to the homes or offices. Just follow these simple instructions then you can take full advantage of the 3G network.
LEDs Front-mounted LED The device has 1 LED. Femto (Red/Green) Green LED State Definition On Power on. Fast Flashing Initialization or temporarily out of service. Slow Flashing One or more calls are currently active. Sequence of two flashing lights No calls can be received currently. Red LED State Definition On Product failure. Single Flashing light No router connection. Sequence of two flashing lights No Internet connection. Sequence of three flashing lights RF issue.
Rear Panel GPS Connector (Optional) The external antenna connector provides connection for an active external GPS antenna. PoE Port Use a standard LAN cable (RJ45 connector) to connect the router. Computer Port Use a standard LAN cable (RJ45 connectors) to connect your PC to the port. Reset This button is used to reset the device to factory default settings. Power Port Connect the supplied power adapter here.
Chapter 2 Initial Installation 2 This Chapter covers the physical installation of the device. Procedure 1. Connect the supplied power adapter to the device. 2. Connect the router to the WAN(PoE) port on the device. 3. Plug the power supply into the main socket. 4. The green light will stop flashing when the device is read to use. It may take a few minutes to complete the process. If the green light does not stop flashing after 30 minutes, please call the operator for help.
Initial Installation 5
3 Chapter 3 Specifications General Specification Connectivity 2 x SMA-J type connectors for internal/external antennae 2 x 10/100 Ethernet ports IEEE 802.3/IEEE802.3i/IEEE802.3u/IEEE802.3x SIM card slot One Power Supply 12V/2A, 100~240V Operating Requirement Operating Temp. 0ºC to 40ºC Storage Temp.
Regulatory Requirements CE Marking CE Mark Directive 1999/5/EC EMC and Radio Compliance ETSI EN 301 908-1 V3.2.1:(2007-05) EMC ETSI EN 301 489-1 V1.6.1 (2005-09) and Draft ETSI EN 301 489-1 V1.7.1 (2006-07) Version EN 301 489-1 V1.8.1 (2008-04) ETSI EN 301 489-23 V1.3.
Safety Information All instructions, warning and caution statements that accompany this equipment must be strictly followed at all times to ensure its safe use. Observe all warning and caution symbols that are fixed to this equipment. This electrical equipment is designed with the utmost care for the safety of those who install and use it.
FCC Regulations: § 15.19 (a)(3) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
