User's Manual
Table Of Contents
- Contents
- Preface
- Overview
- Installation
- Preparing for Installation
- Unpacking the Components
- Installation Guidelines
- Installing the Devices
- Connecting the Protective Ground and Power
- Wiring the Alarm Circuits
- Connecting to Device Ports
29/OCT/2014 REVIEW DRAFT — CISCO CONFIDENTIAL
2-9
Cisco IR500 Series WPAN Gateway and Range Extender Installation and Configuration Guide
Chapter 2 Installation
Installing the Devices
Installing the Devices
• Mounting the WPAN Gateway, page 2-9
• Mounting the Range Extender, page 2-15
Mounting the WPAN Gateway
• Mounting the WPAN Gateway on a DIN Rail, page 2-9
• Mounting the WPAN Gateway on a Wall, page 2-13
Mounting the WPAN Gateway on a DIN Rail
• Attaching the DIN Rail Mounting Bracket to the WPAN Gateway, page 2-9
• Attaching the WPAN Gateway to a DIN Rail, page 2-11
Attaching the DIN Rail Mounting Bracket to the WPAN Gateway
The WPAN gateway is attached to a DIN rail spring loaded mounting bracket (part number
700-103853-01) for mounting on a DIN rail.
To attach the DIN rail mounting bracket to the gateway:
Step 1 Decide if the WPAN gateway is to be mounted in a horizontal or vertical orientation.
Step 2 Align the DIN rail mounting bracket with the mounting hoes as shown in Figure 2-1, and screw the
mounting screws and washers into place. The completed assembly is shown in Figure 2-2.