User's Manual
Table Of Contents
- Contents
- Preface
- Overview
- Installation
- Preparing for Installation
- Unpacking the Components
- Installation Guidelines
- Installing the Devices
- Connecting the Protective Ground and Power
- Wiring the Alarm Circuits
- Connecting to Device Ports
29/OCT/2014 REVIEW DRAFT — CISCO CONFIDENTIAL
2-11
Cisco IR500 Series WPAN Gateway and Range Extender Installation and Configuration Guide
Chapter 2 Installation
Installing the Devices
Figure 2-2 Assembled WPAN Gateway and DIN Rail Mounting Bracket
1 WPAN gateway
2 DIN rail mounting bracket
1
2
391284
Attaching the WPAN Gateway to a DIN Rail
To attach the WPAN Gateway to a DIN Rail:
Step 1 Position the base of the WPAN Gateway (and the attached DIN mounting rail) directly in front of the
DIN rail.
Step 2 Place the spring loaded lower lip of the DIN mounting bracket over the lower edge of the DIN rail as
shown in Figure 2-3, and put pressure on it by pressing it upwards. Maintain the pressure.