User's Manual
Table Of Contents
- Contents
- Preface
- Overview
- Installation
- Preparing for Installation
- Unpacking the Components
- Installation Guidelines
- Installing the Devices
- Connecting the Protective Ground and Power
- Wiring the Alarm Circuits
- Connecting to Device Ports
29/OCT/2014 REVIEW DRAFT — CISCO CONFIDENTIAL
2-30
Cisco IR500 Series WPAN Gateway and Range Extender Installation and Configuration Guide
Chapter 2 Installation
Wiring the Alarm Circuits
Figure 2-21 Inserting Wires into the Alarm Connections
391219
1
2
1 Alarm reference 2 Alarm in
Step 5 Use a ratcheting torque flathead screwdriver to tighten the alarm connector captive screw (above the
installed wire leads) to 2 in-lb (0.23 N-m). See Figure 2-22.
Caution Do not over-torque the power and alarm connector's captive screws. The torque should not exceed 2 in-lb
(0.23 N-m).