User's Manual
Table Of Contents
- Contents
- Preface
- Overview
- Installation
- Preparing for Installation
- Unpacking the Components
- Installation Guidelines
- Installing the Devices
- Connecting the Protective Ground and Power
- Wiring the Alarm Circuits
- Connecting to Device Ports
29/OCT/2014 REVIEW DRAFT — CISCO CONFIDENTIAL
2-35
Cisco IR500 Series WPAN Gateway and Range Extender Installation and Configuration Guide
Chapter 2 Installation
Connecting to Device Ports
Connecting to the USB Port
Note If you are connecting to the USB port:
- a connection (to the USB port) can only be made in a non-hazardous environment
- the USB port cover must be reinstalled before the WPAN gateway can be deployed in a hazardous
environment
To connect to the USB port:
Step 1 Remove the two captive screws that attach the USB port cover to the front panel. See Figure 2-26.
Figure 2-26 Removing the USB Port Cover Captive Screws
391607
1
1 USB port cover
Step 2 Connect the USB cable connector to the USB port. See Figure 2-27.