User's Manual
Table Of Contents
- Contents
- Preface
- Overview
- Installation
- Preparing for Installation
- Unpacking the Components
- Installation Guidelines
- Installing the Devices
- Connecting the Protective Ground and Power
- Wiring the Alarm Circuits
- Connecting to Device Ports
29/OCT/2014 REVIEW DRAFT — CISCO CONFIDENTIAL
1-7
Cisco IR500 Series WPAN Gateway and Range Extender Installation and Configuration Guide
Chapter 1 Overview
Assembly Details
Figure 1-3 Rear Panel of WPAN Gateway IR509U-WP-915/K9 Model
390981
1
1 Console port
You can connect the WPAN gateway to a PC or laptop through the RJ-45 console port. The RJ-45 console
port uses t
he Cisco Console Port RJ45-to-DB9 cable (Cisco part number 72-3383-01).
For information about connecting to the console port, see the “Connect
ing to the WPAN Gateway
Console Port” section on page 5-13.
Bottom Panel—WPAN Range Extender
This section describes the WPAN Range Extender bottom panel components shown in Figure 1-4:
• Antenna Connector, page 1-10
• Hard Points, page 1-10
• Console Port, page 1-10
• Protective Vent Port, page 1-11
• Ground Connection, page 1-11
• Power Connector, page 1-11
• System LED, page 1-11