User's Manual
Table Of Contents
- Contents
- Preface
- Overview
- Installation
- Preparing for Installation
- Unpacking the Components
- Installation Guidelines
- Installing the Devices
- Connecting the Protective Ground and Power
- Wiring the Alarm Circuits
- Connecting to Device Ports
29/OCT/2014 REVIEW DRAFT — CISCO CONFIDENTIAL
2-26
Cisco IR500 Series WPAN Gateway and Range Extender Installation and Configuration Guide
Chapter 2 Installation
Connecting the Protective Ground and Power
Figure 2-17 Crimping the Ground Lug
391287
Step 2 Connect the grounding lug to the range extender ground connection point shown in Figure 2-18 using
the supplied screws. Tighten the screws to 10 to 12 foot-pounds of torque.
Figure 2-18 Installing the Ground Lug
391288
1
1 Ground connection
Step 3 If necessary, strip the other end of the ground wire and connect it to a reliable earth ground, such as a
grounding rod or an appropriate grounding point on a pole that is grounded.