Assembly Instructions

Ripwave Base Station I&C Guide Navini Networks, Inc.

190 Part #40-00047-00 Rev F v1.0 (TTA)

October 23, 2003

RFS Only Transmit Verification

Ensure that the calibration of the test setup and RFS Test Box setup for RFS Only has been

performed each time the test frequency is changed. Refer to Figure O7.

Step 1. Switch the RFS Test Box to the transmit (Tx) mode.

Step 2. Connect the cable from the Spectrum Analyzer to the RFS cal connector. Use a barrel

connector to change the gender, if required.

Step 3. Connect the cable from the Signal Generator to the RFS antenna input number 1. Use a

barrel connector to change the gender, if required.

Figure O7: RFS Only Tx Verification

Note: The position of the RFS will vary the sweep results due to reflections from the test

surface.

Step 4. Take a marker measurement on the Spectrum Analyzer by using the ‘marker to peak’

or the ‘peak search’ function. The screen on the Spectrum Analyzer should look similar

to the one shown in Figure O8.

Barrel connector

Signal Generator

cable to RFS

antenna 1 connector

Spectrum Analyzer

cable to RFS cal