Assembly Instructions

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev F v1.0 (TTA) 223
October 23, 2003
BTS Configuration Form
Company:_________________________________________________________
Your Name:______________________________________ Date:____________
BTS ID/NAME:____________________________________________________
NOTE 1: Field Values in gray rows indicate data that ordinarily should not be changed or that is populated
automatically by the system.
NOTE 2: Default Field Values are underlined.
General Parameters
Status
Field Name Values Description
RF Admin Status Up or Down Determines if the BTS is transmitting Radio Frequency
(RF). Up means transmitting. Down means not
transmitting. To bring the RF Admin Status Up, execute
the Enable action. To bring it Down, execute the Disable
action.
Connected Status True or False Display only. The user cannot set this field. Indicates if
the EMS can communicate with the BTS. The EMS
Server sends a message to the BTS periodically. If the
BTS responds, the EMS sets this field to True. If the BTS
does not respond in a reasonable amount of time, the
EMS changes the Connected Status to false. If the
Connected Status is False, the EMS will not send any
configuration messages to the BTS because it cannot
communicate.
Provisioned Status Provisioned or
Unprovisioned
If Provisioned, the BTS has been configured and is ready
for use.
IP
Field Name Values Description
BTS IP Address Unique IP address for each BTS. Space bar used to
remove or skip existing digits.
EMS Server IP Address Unique IP address for an EMS. Defaults to the IP on
which the EMS Server is running. Space bar used to
remove or skip existing digits.
BTS Default Gateway Default Gateway used to route IP packets for a BTS.
BTS Subnet Mask Subnet Mask used to route IP packets for a BTS.
Street Address Physical location of this BTS.
City City in which BTS is located.
State State in which BTS is located.
Zip Zip code for location in which BTS is located
continued…