Assembly Instructions

Ripwave Base Station I&C Guide Navini Networks, Inc.
248 Part #40-00047-00 Rev F v1.0 (TTA)
October 23, 2003
Test Form Instructions
These instructions explain how and what to enter into the Base Station Calibration Verification
spreadsheet, as well as define each cell’s function. The cells that need an entry are shown in
green on the spreadsheet. This document and form are to be used in conjunction with the Base
Station Installation & commissioning Guide P/N 40-00047-00.
I. Section 1: General Information
A. Date (D4)
Excel will enter the current date.
B. SITE NAME (D5)
Enter site name or customer designation.
C. BTS ID (D6)
Enter BTS identification number or customer description.
D. Frequency (D7)
Enter the system operating frequency that the customer has determined to use.
E. Software Release (D8)
Enter the release number of the software load being used.
F. Name (D9)
Enter your name.
G. Cal cable loss (D12)
Excel will enter averaged value of calibration cable loss from cell E38.
A B C D E F G H I J K L M
64
65
Receiver performance
66
67
Power
splitter loss
UL Tcc Power UL SNR
Absolute Signal
strength
Noise Level Noise Figure
RX Gain
(DAC
word)
68
69 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
70 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
71 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
72 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
73 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
74 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
75 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
76 0.0316 -8.00 12.00 -114.05 -126.05 5.95 145
77
78
79
80
Transmitter Performance
81
82 P out Transceiver
83
Absolute
Sync Level
Power
(RMS)
Power
(peak)
Power at
antenna
(RMS)
Radiated
power
(RMS)
TX Gain
(DAC
word)
84
85 -80.0 36.0 45.49 30.0 48.0 200
86 -80.0 36.0 45.49 30.0 48.0 200
87 -80.0 36.0 45.49 30.0 48.0 200
88 -80.0 36.0 45.49 30.0 48.0 200
89 -80.0 36.0 45.49 30.0 48.0 200
90 -80.0 36.0 45.49 30.0 48.0 200
91 -80.0 36.0 45.49 30.0 48.0 200
92 -80.0 36.0 45.49 30.0 48.0 200
93
94
Power
deviation
0.0 0.0 0.0