Assembly Instructions

Navini Networks, Inc. Ripwave Base Station I&C Guide

Part #40-00047-00 Rev F v1.0 (TTA) 259

October 23, 2003

Step 1. Ensure that the Base Station has successfully completed calibration and RF sanity

measurements at the frequency and TX/RX signal levels that were determined during

the site survey. Ensure that the Base Station is powered on and able to TX/RX data.

Step 2. Create a CPE Descriptor, and assign it to the Modems to be used for the Drive Study:

CPE Descriptor Parameters

Name: Drive Study

Index: Next available number

Priority: 1

UpLink Max Bandwidth: 64

UpLink Min Bandwidth: 32

DownLink Max Bandwidth: 96

DownLink Min Bandwidth: 64

Other parameters: Use defaults.

Step 3. Mount an omni-directional antenna on the roof of the vehicle. This will serve as the

antenna for the Modem.

Step 4. Bring the RF cable from the omni-directional antenna into the vehicle through the

window. Attach the antenna to the antenna input of the Modem. The rotating upright

antenna on the Modem needs to be removed to perform this step. You will also need to

disconnect the patch antennas inside (Figure X3).

Figure X3: Patch Antennas