Connection Diagram

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev F v1.0 (TTA) 139
October 23, 2003
Time Domain
The Time Domain portion of the procedure is for unlicensed systems only.
Step 1. Set the Center Frequency to 2.4025GHz. Set the Resolution Bandwidth to 5 MHz.
Step 2. Set the Video Bandwidth to 1MHz.
Step 3. Set the Sweep Time to 40 ms.
Step 4. Set the Span to 0 Hz.
Step 5. Replace the antenna with a terminator to get a noise floor level. Save a screen capture.
Step 6. Set the display line to the noise floor level. The display line needs to stay on for all of
the following sweeps. This display line is used for a reference point and should be set
with the LNA powered on.
Step 7. Run the Single Sweep approximately 50 times and determine how often the
interference occurs. Save a screen capture of one worst case and one typical. See
Figure E4, Time Domain Screen Capture.
Step 8. Set the Sweep Time to 400 ms, and repeat Step 7.
Step 9. Repeat Steps 7 and 8 for an offset of 5MHz up to 24875MHz for 2.4 systems.