Connection Diagram

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev F v1.0 (TTA) 141
October 23, 2003
Appendix F: Interference Sweep Tool
Overview
The Navini 2.4 GHz frequency Interference Sweep Test tool is used by an Installation &
Commissioning Technician or Field Engineer to sweep and collect data concerning RF conditions at
a specific site. The location is typically a site that has been identified as a potentially good candidate
for a Base Station installation.
The test tool manages the RF sweep and interference level conditions, with post-analysis performed
by RF Engineering personnel using simulation models. The results of the analysis are not a
guarantee of optimal operating conditions for the Ripwave system. The objective is to identify and
eliminate sites that might pose high potential problems in order to prioritize a given list of sites for
Base Station deployment.
Installation
Equipment
1. Navini Survey Test Box
2. 12 pin Control Cable
3. Laptop Computer
4. Power Box With Attached Ethernet Cable
5. Power Cable for the Power Box
Figure F1 is a block diagram showing the requirements to install the equipment. Figure F2 provides
an example of the laptop and cable configuration.
Figure F1: Block Diagram
Navini Test Box
Laptop Computer
AC outlet
Control Cable
Ethernet Cable