Connection Diagram

Ripwave Base Station I&C Guide Navini Networks, Inc.
142 Part #40-00047-00 Rev F v1.0 (TTA)
October 23, 2003
Figure F2: Laptop & Cable Configuration
Mounting
The Navini Test Box should be installed in the location where the RFS will be installed, or as close
as possible. This will give the most accurate representation of the interference at the site. On the
upper portion of the test box there are three labels indicating 0, 120, and 240 degrees (Figure F3).
These are the antennas that are inside the test box. The label indicating 0 degrees should be pointed
as close to north as possible. Connect the Control Cable from the Navini Test Box to the Control
Box. The Control Box has a power connector, a circular control cable connector, and a blue
Ethernet cable on it. The Ethernet cable will be connected to your laptop.
Figure F3: Test & Control Box Setup
0 degrees
120 degrees
240 degrees
Top down view of
Navini Test Box
Control Box
0 degrees
120 degrees
240 degrees
Top down view of
Navini Test Box
Control Box