Connection Diagram

Navini Networks, Inc. Ripwave Base Station I&C Guide
Part #40-00047-00 Rev F v1.0 (TTA) 177
October 23, 2003
For installing the ‘EZ’ connectors on LMR-900-DB, FR and LLPL cables and larger, the process is
as follows:
?? Flush cut the cable squarely.
?? Slide the backnut and gasket onto the cable.
?? Strip the cable-end using the EZ prep/strip tool by inserting the cable into the proper end of the
tool (note that only one strip is needed).
?? Slide the gland washer on the end of the cable and over the braid (being careful not to disturb the
braid) until it rests on the end of the cable jacket.
?? Spread the braid over the gland washer.
?? Slide the collar over the foil.
?? Push the ‘spring finger’ end of the connector pin assembly into the hollow center conductor.
?? Bring up the backnut and gasket.
?? Screw the connector head onto the backnut and tighten with proper size wrenches until the
gasket is almost fully compressed.”
Table N1: Reference Chart Showing ‘EZ’ Connectors For Use with LMR, DB & FR Cables
LMR
?
FR
DB
Interface Description Part
Number
Coupling
Nut
Inner
Contact
Outer
Contact
400 N Male Straight
Plug
EZ-400-
NMH
Hex Spring
Finger
Crimp
400 N Female Straight
Jack
EZ-400-NF NA Spring
Finger
Crimp
400 N Female Bulkhead
Jack
EZ-400-
NF-Bh
NA Spring
Finger
Crimp
400 TNC Male Straight
Plug
EZ-400-
TM
Knurl Spring
Finger
Crimp
400 TNC Male Reverse
Polarity
EZ-400-
TM-RP
Knurl Spring
Finger
Crimp
400 TNC
Female
Reverse
Polarity
EZ-400-
TM-RP
Knurl Spring
Finger
Crimp
400 UHF Male Straight
Plug
EZ-400-
UM
Knurl Spring
Finger
Crimp
600 N Male Straight
Plug
EZ-600-
NMH
Hex Spring
Finger
Crimp
600 N Male Right
Angle
EZ-600-
NMH-RA
Hex Spring
Finger
Crimp
600 N Female Straight
Jack
EZ-600-NF NA Spring
Finger
Crimp
600 N Female Bulkhead
Jack
EZ-600-
NF-BH
NA Spring
Finger
Crimp
600 TNC Male Straight
Plug
EZ-600-
TM
Knurl Spring
Finger
Crimp
600 TNC Male Reverse
Polarity
EZ-600-
TM-RP
Knurl Spring
Finger
Crimp
600
TNC
Reverse
EZ
-
600
-
NA
Spring
Crimp