Installation Instructions Chapter 1

Ripwave Base Station I&C Guide Navini Networks, Inc.
Chapter 1
20 Part #40-00047-01 Rev F v1.0 (TTA)
October 23, 2003
Chapter 1: Overview
Ripwave Description
A Ripwave system has three main components: the Customer Premise Equipment (CPE); the
Base Station; and the Element Management System (EMS). The Base Station performs the CPE
registration and call processing, and provides the interface between the backhaul network and the
EMS. It is made up of the Base Transceiver Station (BTS) and the Radio Frequency Subsystem
(RFS) (Figure 1). This manual provides the guidelines and instructions for installing and
commissioning (I&C) the Base Station.
Figure 1: Base Station Installation (Combo and Split-Chassis Configurations)
Grounding
kits for
Coax Cable
Antenna
Bracket
Omni or Panel Antenna
Lightening
Ground
GPS Antenna
RF Shelf
Digital Shelf
Rectifiers (24 VDC, 60 A)
Cal cable
P&D cable Polyphasor
Power & Data cable
RF cables
Frame
Ethernet
110 VAC
Demarc.
PSX
PSX-ME
DGXZ+06NFNF-A
Power & Data
Cable Surge
Protector
GPS
Surge
Protector
Surge
Protectors Surge
Protectors
Grounding
kits for
Coax Cable
Antenna
Bracket
Omni or Panel Antenna
Lightening
Ground
GPS Antenna
RF Shelf
Digital Shelf
Rectifiers (24 VDC, 60 A)
Cal cable
P&D cable Polyphasor
Power & Data cable
RF cables
Frame
Ethernet
110 VAC
Demarc.
PSXPSX
PSX-MEPSX-ME
DGXZ+06NFNF-ADGXZ+06NFNF-A
Power & Data
Cable Surge
Protector
GPS
Surge
Protector
Surge
Protectors Surge
Protectors