Installation Instructions Chapter 2a

Ripwave Base Station I&C Guide Navini Networks, Inc.
Chapter 2a
52 Part #40-00047-02 Rev E v1.0 (TTA)
October 23, 2003
Install Connectors on Cables
Install connectors on both ends of each cable. For LMR 600 cables, install EZ-600 N-type male
connectors. For LMR 400 cables, install EZ-400 N-type male connectors. Steps for installing
both types of connectors can be found in Appendix N. For reference, Appendix L also provides a
list of vendors who can make cables.
The Cal and RF cables in the Combo and Split Chassis configuration have N-type male
connectors at both ends. The Bundle Cable used with the TTA configuration has N-type male
connectors at the antenna end, but the connectors used at the other end depend on the degree of
lightning protection desired. Is only the built-in protection is used, the connectors at the BTS
end are QMA male, but if the Ancillary surge protectors are used, the connectors at the BTS end
of this cable are N-type male.
Figure 19: Connectors.
N-Type
F M
QMA
M
BNC
F M
RG6
Front
Back
RG11 BNC RJ45/RJ48
N-Type
F M
QMA
M
BNC
F M
RG6
Front
Back
RG11 BNC RJ45/RJ48