Installation Instructions Chapter 2a

Navini Networks, Inc. Ripwave Base Station I&C Guide
Chapter 2a
Part #40-00047-02 Rev F v1.0 (1.20) 47
October 9, 2003
Antenna Ground Buss Bar
You should install the Antenna Ground Buss Bar on the mounting structure per accepted telecom
standards and procedures (Figure 13). The location is decided on during the site survey and
should be close to the RFS. Two or more buss bars may be installed per system.
Figure 13: Buss Bars
System Ground Wiring
A minimum #6 stranded, green-coated copper wire and grounding hardware are used for ground
connections. Install the system ground as a single-point connection between the system ground
buss bars, the data/power surge protector, the BTS chassis, the BTS mounting rack, and the RFS
antenna. Connect the system ground to earth ground. Apply anti-oxidant joint compound to all
connections (Figure 14). Tighten all connections until secure.
Figure 14: Applying anti-oxidant joint compound
Antenna Buss BarBTS Buss Bar Antenna Buss BarBTS Buss Bar