Installation Instructions Chapter 2b

Ripwave Base Station I&C Guide Navini Networks, Inc.
Chapter 2b
58 Part #40-00047-03 Rev F v1.0 (TTA)
October 23, 2003
Power-interconnect wires between the power supply/rectifier and the digital chassis must have
heat shrink tubing applied over the barrel of the terminal lugs after crimping the wire. Refer to
Figure 25 below.
Figure 25: Power-Interconnect Wires
1. Install UL-Listed Terminals
2. Slide on heat-shrink tubing
3. Apply heat to shrink tubing 4. Install power cables
1. Install UL-Listed Terminals
2. Slide on heat-shrink tubing
3. Apply heat to shrink tubing 4. Install power cables