Installation Instructions Chapter 2d
Navini Networks, Inc. Ripwave Base Station I&C Guide
Chapter 2d
Part #40-00047-05 Rev F v1.0 (TTA) 67
October 23, 2003
Connect Ground Wires to the Ground Buss Bar
Connect the ground wires on the cables to the ground buss bar using the hardware supplied with
the grounding kit. Connect the ground stud on the RFS to the ground buss bar. Use a ΒΌ-inch
terminal lug to connect the ground wire to the ground stud on the RFS. Connect the ground buss
bar to earth ground. An example is shown in Figure 36.
Figure 36: RFS Grounding
Test the RFS & Cables
Test the RFS and the eight (8) cables using Appendix O, the RFS System Test Form. Record the
results in the form. For this test, use the cable connectors that will be attached to the BTS.
Include the jumpers and all surge protectors.
Ground Buss Bar
Ground Wires
Earth Ground Ground Buss Bar
Ground Wires
Earth Ground