Product Info Chapter 2e

Navini Networks, Inc. Ripwave Base Station I&C Guide
Chapter 2e
Part #40-00047-06 Rev F v1.0 (TTA) 71
October 23, 2003
Omni Antenna
The RFS Omni antenna is installed on a structure, such as a tower or a pole, which is defined in
the site survey and design. Following are the steps to complete the installation of the panel
antenna. Refer to the Regulatory Information in Chapter 1, Page 8 prior to installing.
Assemble the Antenna Mount per the instructions that come with it (Figure 43). Use a compass
to determine which direction is true East (incorporating declination angle - see Figure 31).
Figure 43: Omni Antenna Mount
Position the Antenna Mount in a direction to provide accessibility to the RFS after it is installed.
Position and install the Antenna Mount on the mounting structure so that any one of the eight
mounting hole pins is facing East. Tighten the Antenna Mount hardware to secure it to the
structure (Figure 44).
Figure 44: Secured Omni Antenna Mount
Mounting Hole Pin