User's Guide

Ripwave Unit Installation and User Guide Navini Networks, Inc.
Ethernet Connections
The following instructions are for the installation of the Ripwave CPE using an Ethernet
connection. Please read all instructions before attempting installation. It is recommended that
the computer and the Ripwave CPE be turned off before performing the installation.
1. Connect the Ethernet cable to the
Ethernet port on the computer
as shown.
2. Connect the other end of the
Ethernet cable to the Ripwave
CPE as shown.
E
t
h
e
rn
et
P
o
r
t
3. Connect the AC power adapter
cable to the Ripwave CPE.
Plug the other end of the AC
power adapter cable
into a 110 VAC outlet.
CAUTION: Only use the
AC power adapter supplied
with the Ripwave CPE. Using
any other adapter may cause
damage to the Ripwave CPE.
AC Power
adapter cable
j
ac
k
40-00098-00 Rev A v1.0
9