User's Guide

Ripwave Unit Installation and User Guide Navini Networks, Inc.
4. Rotate the antenna on the
Ripwave CPE clockwise
180 degrees to the ‘UP’ position.
This reveals the Ripwave CPE
indicator lights.
CAUTION: Rotation or movement
of the antenna in any other
direction may cause damage
to the Ripwave CPE.
On/Off switch
Rotate
antenna
clockwise
180 degrees
Signal Strength Indicator
Battery Indicator
Power Indicator
5. Push the On/Off switch
on the Ripwave CPE to turn the
CPE ON.
6. If the green power indicator light is
on, proceed to step 7. If the green
Power Indicator light is not on, there
is a problem with the Ripwave CPE
or the AC power adapter. Check all
cables for proper connection.
Otherwise, contact the supplier
from whom you obtained
the package.
Power Indicator
7. Set the power switch on the computer to the ON position. When the system is up, log
in to the computer.
8. Proceed to the Ripwave Monitor Software Installation procedure on page 11.
0-00098-00 Rev A v1.0
10