User's Guide

Ripwave Unit Installation and User Guide Navini Networks, Inc.
Ripwave Monitor Software Installation
The Ripwave Monitor provides information on the strength and quality of the incoming
signal and battery strength. It also checks the connectivity to the Internet Service Provider
(ISP) network.
Notes:
· For Windows NT
®
and Windows
®
2000, you must be logged into an account
having administrative privileges to install the Ripwave Monitor software.
· For Ripwave Monitor software installation on Windows
®
95, Windows
®
98, and
Windows
®
98SE Operating Systems, the operating system CD may be needed to
complete the installation. If prompted, insert the operating system CD in the
CD-ROM drive and accept the defaults.
Installation Procedures
The following instructions are for installing the software that monitors the operation and
performance of the Ripwave CPE.
1. Shut down all programs before installing the Ripwave Monitor software. This
includes all anti-virus software.
2. Insert the Navini Networks Ripwave Installation CD in the CD-ROM drive.
3. Click Start > Run at the bottom left corner of your screen. In the Run window, enter
e:\setup (where “e” represents the CD drive; use the letter representing your specific
CD drive) in the Open field. Click OK to continue.
40-00098-00 Rev A v1.0
11