User's Manual

11
Overview of the Cisco LoRaWAN Interface Module
Hardware Features
 Power-over-Ethernet (PoE+, 30W)
 DC power—48 VDC
Warning: Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning: This equipment must be externally grounded using a customer-supplied ground wire before power is
applied. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable
grounding is available. Statement 366
Warning: Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
1001
Warning: Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950 based safety standards. Statement 1033
Warning: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
Statement 1023
Caution: Do not place the power injector in an unprotected outdoor environment because water could get into the power
injector and cause a short circuit and possible fire.
Ethernet (PoE+) Ports
The Cisco LoRaWAN Interface Module supports an Ethernet uplink port (PoE-In). The RJ-45 connector (with
weatherproofing) links the device to the 10BASE-T or 100BASE-T network. The Ethernet cable is used to send and
receive Ethernet data and to optionally supply inline 54-VDC power from the power injector.
The Ethernet cable must be a shielded outdoor rated Category 5 (CAT5) or better cable. The Cisco LoRaWAN Interface
Module senses the Ethernet and power signals and automatically switches internal circuitry to match the cable
connections.
Reset Button
A Cisco LoRaWAN Interface Module that has already been configured can be reset to the manufacturing configuration
by pressing the Reset button located at the side of the CONSOLE port on the device.
If you press the Reset button and release it in less than 5 seconds, the system will reboot immediately with the last saved
configuration.
If you press the Reset button and release it after more than 5 seconds, the system will reboot immediately and restore
to the factory default.